MONTANATM 6 TENT MODEL 2000001593
Before you begin
Read all instructions before set up.
•Select a level site clear of rocks, branches, and other hard or sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
•Do not set up your tent under trees because of potential lightning strikes or falling tree limbs in inclement weather.
•Secure with all stakes and guylines provided to prevent property damage or personal injury.
•For best results in windy conditions, position narrow end of tent into the wind.
•Enlist the help of at least one other person to assist you when it is time to assemble the tent.
Pole Descriptions
|
| Pole | Pole | Pole |
Description | Qty. | Dia. | Repair Kit | Replacement Kit |
Main Body Pole, black | 2 | 9.5mm | 501000540 | 501000548 |
Side Body Pole, grey | 2 | 9.5mm | 501000540 | 501000548 |
Rainfly Pole, black | 1 | 9.5mm | 501000540 | 501000548 |
STITCH LINE
To Set Up Tent
1.Unfold tent and spread out on a clean, level surface with
the door facing the desired direction. (Fig. 1)
2. Assemble all poles by interlocking the
3. Insert grey Side Body Poles through the grey trimmed sleeves on both sides of tent; then insert black Main Body Poles through black trimmed sleeves, in center of tent, forming a “X”. Make sure black Main Body Poles overlap the grey Side Body Poles. (Fig. 1)
4.Insert end of each black Main Body Poles & grey Side Body Poles into pins. (Fig. 2 & 2A)
5.Go to opposite end of each pole and gradually apply pressure to each forming arches. Insert the pin into each pole end at the sides and corners of tent. (Fig. 2 & 2A)
6.Attach frame clips along edges of tent to the black Main Body Poles & grey Side Body Poles. (Fig. 2B)
7.Stretch tent until taut, then secure metal loops located on both sides and web loops located at four corners of tent with stakes. (Fig. 2C)
2C
Sleeves with Black Trim |
| Fig. 1 | |||
Sleeve with | Black, | ||||
Grey Trim | Main Body Poles | ||||
|
|
| Sleeve with | ||
| Door | ||||
|
|
|
| Grey Trim | |
Front of Tent |
| ||||
|
|
| |||
Grey, |
|
|
| ||
|
|
|
|
|
|
|
|
|
|
| 2B |
|
|
|
|
| |
2A
Door
Fig. 2
To Attach Rainfly
1.Insert black Rainfly Pole with through sleeve in underside of Rainfly. (Fig. 3)
2.Drape Rainfly over tent with Rainfly Pole centered above front door & the green vestibule flaps located in the front. (Fig 4).
3.Insert end of each black Rainfly Pole into pin on either side of front door. (Fig. 4 & 4A)
4.Go to opposite end of Rainfly Pole and gradually apply pressure to form an arch. Insert the pin into pole end at other side of the door. (Fig. 4 & 4A)
5.Locate all hook & loop fasteners on underside of rainfly and wrap around black and grey poles to secure. (Fig. 4B)
6.Stretch elastic straps and hook clip on each to the metal loops at the front and back of the tent. (Fig. 4C)
Rainfly Sleeve | Black Rainfly |
| Pole |
|
Door
Fig. 3
Fig. 4
Rainfly
Black
Rainfly
Pole
(continued on other side)
4B4A
4C
