Porter-Cable 4210 & 4212 instruction manual Setup

NOTE: The instructions given here are for templates mounted to the base of the jig. However, this joint can also be made with templates mounted to angled clamping boards. You must use the angled clamping board for steeper angles.

Use the following table for setting up your table saw for these cuts:

DESIRED SIDE ANGLE	MITER gauge ANGLE	BLADE TILT ANGLE
85°	85.0°	89.6°
80°	80.1°	88.3°
75°	75.5°	86.2°
70°	71.1°	83.3°
65°	67.1°	79.7°

SETUP

Use the same setup as you would for the obtuse angled joint. Use the blade tilt angle for making the angle insert or the angled clamping block. Bevel the edges according to the drawing (Fig. 63A).

BEVEL THE EDGES OF THE TAIL AND PIN BOARDS

Fig. 63A

FIRST CUT BLADE TILT ANGLE

THICKNESS OF PIN BOARD

	90.0°
	SECOND CUT
OUTSIDE	INSIDE
SURFACE	SURFACE
OF BOARD	OF BOARD

Fig. 64A

Step 1 - Cut the end of the tail board according to the drawing (Fig. 64A). Set the miter gauge and tilt the blade to the values in the above table. Make the first cut with the board flat on the table surface and guide it with the miter gauge (Fig. 64B). Make the second cut with a tenoning jig (Fig. 64C).

Fig. 64B

Fig. 64C

35