Porter-Cable 4210 & 4212 instruction manual Wooden Hinges, Hinges with a Drilled Hole

WOODEN HINGES

A wooden hinge can be used to make hinged table leafs or hinged legs for a collapsible table. The hinge pins are normally are made of stainless steel, but you can use other materials, including wood for that purpose.

180° HINGES WITH A DRILLED HOLE

The workpiece for this simple hinge must be narrow enough to make the hole for the hinge pin with a drill bit. This hinge has at least a range of motion of 180° (Figs. 45A and 45B).

Fig. 45A

Fig. 45B

Step 1 -

Step 2 -

Step 3 -

Step 4 -

Step 5 -

Step 6 -

Step 7-

Round over the ends of the two workpieces (Fig. 45C).

Use a drill press to drill a hole in the center of each board for the hinge pin (Fig. 45D).

Make an end-to-end box cut. (Make the depth-of-cut slightly deeper than the thickness of the boards (Fig. 45E).

Make the length of the hinge pin narrower than the width of the boards Hold the boards together, align the holes, and insert the pin (Fig. 45F). Glue wooden plugs in the workpiece to hold the pins in place.(Fig. 45G). Cut off the protruding part of the plugs and sand (Fig. 45H).

Fig. 45C

Fig. 45D

Fig. 45E

Fig. 45F

Fig. 45G

Fig. 45H

26