Assembly
HAND TOOLS REQUIRED (not provided):
•Phillips Screwdriver
•Small Adjustable Wrench
■Assemble three legs to the shelf. The shelf is threaded to receive the screws (Fig. 2). Invert the shelf and attach each leg with two screws. Notice that for this step, the legs are positioned with the large end downward (Fig. 3). Hand tighten the six screws.
Hardware shown actual size
Screw (6) Qty. | Fig. 2 |
|
Assembly is inverted in this view
Fig. 3
■Turn the shelf and legs upright. Position the frame on the legs. Attach any two legs to the frame using two screws and two hex nuts per leg (Fig. 4 and 5).
NOTE: Do not completely tighten these fasteners until later. This will allow easier alignment during assembly of the control panel.
NOTE: The third leg will be fastened later when the control panel is assembled to the frame.
Hardware shown actual size
Screw (4) Qty.
Hex Nut (4) Qty. |
|
Fig. 4 |
Fig. 5
■Assemble the Control Panel by slipping the flange between the frame and the third leg. Grasp the frame and raise slightly to create clearance for the flange. Fasten with two screws and two hex nuts (Fig. 6, 7 and 8).
NOTE: Do not completely tighten these fasteners until later. This will allow easier alignment while securing the bottom of the control panel with screws.
Hardware shown actual size
Screw (2) Qty.
Hex Nut (2) Qty. |
|
Fig. 6 |
Fig. 7
