Coleman 5071 Series manual Setup with Hose and Refillable Cylinder, English-7

Setup with Hose and Refillable Cylinder

(hose sold separately)

WARNING

•Read and follow all instructions and warnings provided with your appliance.

•Do not store LP gas cylinders under or near this appliance.

•Never fill the cylinder beyond 80% full.

•Failure to follow the above instructions exactly may result in fire causing death or serious injury.

•A disposable propane cylinder must not remain connected to the fireplace when using the hose and refillable cylinder. Install the shut-off plug into the remaining fuel connection.

•When using extension hose always point the cylinder valve toward the fuel inlet of the appliance.

•Maintain proper clearances between cylinder and appliance. The cylinder must be positioned with 60 inch clearance between the cylinder and the inlet of the gas fireplace.

•Clean and inspect the hose before each use. If there is evidence of abrasion, wear, cuts or leaks, the hose must be replaced prior to use. The replacement hose must be that specified by The Coleman Company, Inc.

•Never alter in any way or use with any device or part not expressly approved by Coleman.

INSTRUCTIONS FOR USE

•High Pressure Hose Extension R5071-522 is only for use with Coleman gas fireplace model 5071. See your dealer or contact Coleman to purchase the accessory hose.

•The LP-gas supply cylinder to be used must be constructed and marked in accordance with the specifications for LP-gas cylinders of the U.S.

Department of Transportation (DOT) or the National Standard of Canada, CAN/CSA B339, cylinders, spheres and Tubes for the Transportation of Dangerous Goods.

•If a refillable cylinder is used, it must have a collar to protect the cylinder valve.

ASSEMBLING HIGH PRESSURE HOSE:

■Close the burner valve firmly (Fig. 28).

Fig. 28

■Remove the plastic protective cap from the shut-off plug. Install the shut-off plug into the left fuel connection (Fig. 29 and 30).

■Attach the 8’ accessory hose to the right side connector on the Fireplace (Fig 31).

Fig. 31

■Attach the hose to the cylinder (Fig 32).

Fig. 32

■Open cylinder valve and perform leak check on Hose to Regulator, and Hose to Cylinder con- nections with soapy water. Bubbles indicate a leak. Check that the connection is not cross- threaded and that it is tight. Perform another leak check. If there is still a leak, remove the cylinder and contact Coleman for service or repairs (Fig. 33 and 34).

Fig. 33

Fig. 34

Fig. 29

Fig. 30

English-7