nRemove lantern parts from package.
Igniter Electrode | Lantern Frame |
Reflector |
|
| Base |
nNote: Use Coleman 16.4 oz. disposable propane cylinders. The
Ball | Mantles | |
Assembly | Nut |
n Always use genuine Coleman® #21 size |
mantles. If using |
follow the instructions on the mantle package. |
n If using tie style mantles, tie mantles around |
nTake lantern outdoors away from ignition sources.
nTurn fuel valve off. (Fig. 7)
Fig. 7 |
nRemove protective cap from top of propane cylinder. Save cap for use in storing. (Fig. 8)
Fig. 8 |
grooves in burner. (Fig. 1) |
n Distribute folds on mantle evenly. Cut off |
surplus string 1/4" (0.6 cm) from knot. (Fig. 2) |
n For INSTASTART™ electronic ignition lanterns, |
be careful that mantle does not snag |
on electrode. |
DANGER
• EXPLOSION - FIRE HAZARD |
Fig. 1 |
Fig. 2 |
• Propane is heavier than air and can |
accumulate in low places. If you smell gas, |
leave the area immediately. |
• Always attach or detach propane source |
outdoors; never while lantern is lighted, near |
flame, pilot lights, other ignition sources or |
while lantern is hot to touch. |
• Always light & use lantern outdoors. |
• This lantern must not be exposed to |
nLight bottom of mantle evenly. Burn until nothing but white ash remains. Once the mantle has been burned, it is very fragile. Be careful not to touch it with finger or match. (Fig. 3, 4)
flammable vapors or liquids during lighting. |
• This lantern is red hot during use and can |
ignite flammables too close to the mantles. |
Keep flammables at least 12 inches from |
Fig. 3 |
Fig. 4 |
the sides and 48 inches from the top of the |
lantern. Keep gasoline and other flammable |
liquids and vapors well away from lantern. |
nAlways extend base before use. (Fig. 9)
nComplete assembly. (Fig. 5, 6)
Fig. 5 |
To Light
Fig. 6 |
n Screw propane |
cylinder into lantern. |
Take care not to |
nSet lantern into base. (Fig. 11)
WARNING
If you smell gas:
1.Do not attempt to light appliance.
2.Extinguish any open flame.
3.Disconnect from fuel supply.
4.Call
WARNING
•Replace any mantle with a hole in it. A hole can cause lantern to overheat and create a hazard. Never operate lantern without heat shield.
tighten only. (Fig. 10) |
Fig. 10 |