3 Add Side & Front Poles,

Attach Frame Clips

– Insert side poles into pole sleeves above rear doors. Insert front pole into pole (gray) sleeve above front door. (illus. 5)

Insert pin on stake loops into the end

of side and front tent poles. (illus. 3, illus. 4)

– Go to opposite end of pole and gradually apply pressure to the pole forming an arch until you are able to insert the pin into the pole end. Repeat for remaining poles.

Attach frame clips to frame poles. (illus. 5, 6)

Stake out all additional loops.

Grommets for rainfly poles

illus. 6

Frame clips

illus. 5 Assembled tent without rainfly. Note the frame clips located on edge of tent.

Attach Rainfly

Right side logo

 

4 – Drape rainfly over tent frame, with logos

illus. 7

Rainfly

on each side of tent. (illus. 7, 8)

 

Connect the elastic loops with “S” hooks on the rainfly corners, to the fabric loops on the frame clips.

– Assemble all rainfly poles.

 

illus. 9

– Insert side (black) rainfly poles through

Pet Den shown

pole sleeve on underside of rainfly above

set-up with pole

the rear doors. Insert front (gray) rainfly

and staked out.

 

pole in pole sleeve above front door.

 

 

Gently bend and insert tips of the rainfly

 

poles into the grommets above the doors.

 

(illus. 5, 8)

 

 

– Secure rainfly with attachments

 

 

located on underside of fly. (illus. 8)

 

 

– Attach and stake out guylines.

 

 

Pet room: Insert pet room pole through

 

 

pole sleeve and gently bend until

illus. 8 Completed tent with rainfly.

you can insert tips into grommets

on stake loops. (illus. 9)

 

 

Front of Rainfly

Insert Front Rainfly pole through pole sleeve on underside of rainfly.

Guyline

Things You Should Know

Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.

Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.

TENT POLES SHOULD NOT BE LEFT TELESCOPED

TOGETHER DURING STORAGE.

Seam sealer has not been provided with your tent. For additional protection we recommend seam sealing your tent prior to camping. Seam sealer may be purchased through your local retailer or at your local sporting goods store.

Do not leave your tent set-up for weeks at a time, be aware that exposure to the ultraviolet rays of the sun can seriously damage nylon material and/or cause it to become discolored.

WARNING: KEEP ALL FLAME AND HEAT SOURCES

AWAY FROM THIS TENT FABRIC. This tent meets the flammability requirements of CPAI-84. The fabric will burn if left in continuous contact with any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.

IMPORTED BY

SUNBEAM CORPORATION (CANADA) LIMITED

DBA JARDEN CONSUMER SOLUTIONS

20B Hereford Street, Brampton, Ontario L6Y 0M1

1-800-387-6161 • www.colemancanada.ca

MADE IN CHINA

PRINTED IN CHINA REV. 12/07

Page 2
Image 2
Coleman 9230-174c manual Add Side & Front Poles Attach Frame Clips, Attach Rainfly, Made in China