Coleman 9790 manual English-7, Changing the Gas Tip, No Groove, Stove Set Up

4 Changing the Gas Tip

NOTE: Make sure the hole in the gas tip easily slips over the clean-out wire. If the wire bumps the gas tip, damage to the clean-out wire may occur.

FUEL	GAS TIP
Coleman® Fuel	No Groove
Unleaded gasoline	No Groove
Kerosene	Groove
Coleman® 3250 Butane/Propane	No Groove

No

Groove

Groove

FIG. 3
■ Turn the flame adjuster fully counter-clockwise	to lower the clean-out
wire (Fig. 4).

■Remove the impingement plate (Fig. 5).

■Use the combination tool provided with the stove to replace the gas tip (Fig. 6).

■See chart above to match the fuel type with the correct gas tip.

■Reinstall the impingement plate.

Lower the clean-out wire.

FIG. 4

Stove Set Up

5

FIG. 5 FIG. 6

NOTE: The reflector disc and windscreen are not illustrated in the set up instructions. This is so the features of the stove may be clearly visible and identified. Read about the reflector disc and windscreen in Sections 1 and 17.

■Unfold stove by lifting legs out of detents and rotating out until legs snap into the open position (Fig. 7). Place the stove on the reflector disc.

FIG. 7

English-7