Coleman 9987 Series instruction manual Rotisserie Burner Lighting cont, Match Lighting, English-10

Rotisserie Burner

Lighting (cont.)

INSTASTART™ Electronic Ignition Rotisserie:

1.Open the lid.

2.Make sure all valves are OFF.

3.Turn on the cylinder valve.

4.Push in and turn on the Rotisserie Control Knob counterclockwise to HIGH, then repeatedly press the igniter switch until the flame ignites (Fig 19).

5.If ignition does not occur in 5 seconds, turn the Rotisserie Control Knob off, wait 5 minutes, and repeat the lighting procedure.

6.If the burner does not light after trying again, turn off Rotisserie Control Knob and try match lighting the burner.

HINT: If the igniter fails to light the rotisserie burner, adjust electrode tip with needle- nose pliers. A spark must jump near a gas opening in the burner when igniter is activated. Use care not to damage the ceramic insulator on electrode.

Push

Repeatedly

Fig. 19

7.Observe the flame from below the rotisserie.

8.Flame should be blue with a hint of yellow on tips.

9.Adjust flame with the control knob (Fig. 20).

Fig. 20

Match Lighting:

CAUTION

Use a LONG wooden match or a butane lighter with an extension. Make sure all burner controls are off except for the burner being lighted. If a long-reach match or lighter is not accessible, use the match extension. The match extension is located inside the doors. Insert a match in the holder end of the extension, strike and place the burning match near the BURNER being operated.

1.Open the lid.

2.Make sure all valves are OFF.

3.Turn on the cylinder valve.

4.Strike and place the burning match near the rotisserie burner, then push in and turn on the Rotisserie Control Knob counterclockwise to HIGH (Fig. 21).

Fig. 21

5. Adjust flame with the control knob (Fig. 22).

Fig. 22

English-10