Coleman PM0601100 manual Electric Start Wiring, Dc Features, Battery Installation, English

Models: PM0601100

1 16
Download 16 pages 6.28 Kb
Page 3
Image 3
ELECTRIC START WIRING

ELECTRIC START WIRING

The generator is equipped with electric start. An “Off-On- Start” rotary key switch is provided on the recoil end panel. All necessary wiring is provided. The battery is customer provided. See engine manual for wiring diagram (3A Charge Coil), and additional information.

DC FEATURES

The charging system of the unit is supplied by the starter/alternator of the engine. 12 volts DC is constantly charging the battery when the unit is running . Disconnecting the battery will stop the charging of the battery.

Before charging a storage battery, check the electrolyte fluid level in all the cells. (Sealed batteries do not require checking). Add distilled water to each cell if necessary, to bring the level back up to the manufacturer’s required level.

DC FEATURES WARNING: Storage batteries give off EXPLOSIVE hydrogen gas while charging. Do not allow smoking, open flames, sparks, or spark producing equipment in the area while charging.

BATTERY INSTALLATION WARNING: Battery electrolyte fluid is comprised of sulfuric acid that can be very dangerous and cause severe burns. Do not allow this fluid to contact eyes, skin, clothing, etc. If contact or spillage does occur, flush the area with water immediately.

CAUTION: This battery charging system is intended to recharge weak batteries, not to "boost start" vehicles. Do not overcharge battery or leave battery unattended.

CAUTION: Do not continue to charge a battery that becomes hot or is fully charged.

BATTERY INSTALLATION

Coleman Powermate, Inc. recommends a 12 V battery with at least 235 cranking amps, Model U1L, Lawn and Garden Battery. Place the battery in the position provided. Place the spacers and washers on the bolts, then place the bolts through the loops on the Hold-Down bracket. Place the assembly over the battery and place the bolts through the holes on the battery pan and tighten down the Hold-Down assembly with the 1/4-20 nuts provided.

Spacers may be removed depending on the battery height.

BATTERY KIT PARTS LIST WARNING: Batteries contain sulfuric acid (when filled). May contain explosive gasses. Always abide by safety warnings provided with the battery.

-Keep sparks, flame and cigarettes away.

-Hydrogen gas is generated during charging and discharging.

-Always shield eyes, protect skin and clothing when working near batteries.

Connect the red 8 ga. battery lead to the positive (+) battery post and the black 8 ga. battery to the negative (-) battery post with the bolts and nuts provided.

BATTERY KIT PARTS LIST

Item

Description

Qty.

A.

*Bolt, 1/4-20 X 8”

2

B.

*Washer 1/4

2

C.

*Spacer

2

D.

Hold Down bar (P/N 0036525.02)

1

E.

*Nyloc nut, 1/4-20

2

*These are standard parts available at your local hardware store.

 

 

 

English

3

 

 

 

Page 3
Image 3
Coleman PM0601100 manual Electric Start Wiring, Dc Features, Battery Installation, Battery Kit Parts List, English