Compaq manual S Pecifications, Quickspecs, Compaq NC6133, Gigabit Module 1000 LX, Ease Of Use

QUICKSPECS

Compaq NC6133

Gigabit Module

1000 LX

..........................................................

..........................................................................................................................................................

EASE OF USE

CPQNTAC

The CPQNTAC (Compaq Network Teaming and Configuration) utility allows the user to run initial diagnostics and configure NIC teams for Network Fault Tolerance, Adaptive Load Balancing or Cisco Gigabit EtherChannel (when used with a Gigabit EtherChannel-enabled switch)

Diagnostic LEDs

LEDs show link integrity and network activity at a glance for easy troubleshooting.

Compaq Total Solutions

The NC6133 provides a 1000 Mbps LX network connection between servers and the Compaq SW5411, SW5425, SW5450 and the GIGAswitch/Router. By integrating these Compaq solutions throughout a network, users can apply the complete set of Compaq management tools across their enterprise.

Warranty1

Compaq supports this product with a limited lifetime warranty1. Technical support is available at your fingertips 24 hours a day, 7 days a week.

SPECIFICATIONS

Compliance	IEEE 802.3z compliant 1000 Mbps Ethernet specification
	PCI 2.1
General Specifications
Communications Processor	Intel 82542
	Half and full duplex
On-board memory	64 KB
Data path	32 and 64-bit/33MHz
Interrupt levels	INTC
Bus architecture	PCI bus-mastering
Connectors	SC
Wavelength	LX = (1,300nm)
Distance	up to 5,000 meters
Wiring	Multi-mode fiber (62.5∝ m)
Dimensions (LxW)	6 x 2.5 in/15 x 6.4 cm

64-bit addresses for systems with more than 4 GB of physical memory 64-bit PCI host interface compliant with PCI 2.1

Command usage optimization for advanced PCI commands (MWI and memory reads) Software controlled global reset bit (resets everything except PCI configuration registers)

Power and Environmental Specifications
Operating
Temperature	32° to 131°F/0° to 55°C
Humidity	10% to 90%
Non-operating
Temperature	–85° to 185°F/–65° to 85°C
Humidity	5% to 95%
Power requirement	1025 mA @ 5V max
Emissions standards	FCC Class B
Safety compliance	CE Mark

11-28DA-10307-01-001