
"Compaq.com - Compaq Presario 1200 Series Maintenance and Service Guide - Models: 1230 and 1232 |
|
|
| ||
|
|
|
|
| |
Computer is beeping and battery LED |
| Battery charge is low. |
| Immediately save any open file(s). | |
icon is blinking. |
|
|
| Then do any one of the following: | |
|
|
|
| ● | Connect the computer to an |
|
|
|
|
| external power source to |
|
|
|
|
| charge the battery pack. |
|
|
|
| ● | Turn off the computer or |
|
|
|
|
| initiate Hibernation until you |
|
|
|
|
| can find another power source |
|
|
|
|
| or charge the battery pack. |
|
|
|
|
|
|
Computer battery LED icon (front on |
| Volume is turned down too low. |
the unit) blinks to indicate low |
|
|
battery condition, but computer does |
|
|
not beep. |
|
|
|
|
|
Battery LED icon doesn't light and |
| Battery pack is already charged. |
battery pack won't fast charge. |
|
|
|
| Battery pack was exposed to |
|
| |
|
| temperature extremes. |
|
| Battery pack is at end of its life. |
|
| |
|
|
|
You have to set the date and time |
| RTC battery is dead. |
every time you turn on the computer. |
|
|
|
|
|
Adjust the volume.
No action is necessary.
Allow time for the battery pack to return to room temperature.
Replace battery pack.
Replace the RTC battery.
Problem |
| Probable Cause |
| Solution(s) |
|
|
|
|
|
Battery charge does not last as long as expected.
Battery is being exposed to high temperatures or extremely cold temperatures.
Keep the battery pack within the recommended operating temperature range 50° F to 104° F (10° C to 40°
C)or recommended storage range
Battery pack is warm to the touch after charging.
Battery pack operating time is far less than the documented average operating time.
Battery has partially
Power management is disabled.
An external device or PC Card is draining the battery.
Normal warming has occurred due to charging.
Power management is turned off or disabled.
An external device or PC Card is draining the battery.
Recharge the battery. Discharge the battery completely and then recharge it.
Set a power management level in Computer Setup.
Turn off or disconnect external devices when not using them.
No action is required.
Enable power management in Computer Setup and in Windows Power Properties.
Turn off or disconnect external devices when not using them.
file:///C/SERVICE%20MANUALS/COMPAQ%20_%20chec...RIO%201200%20SERIES%201230%201232/solving.html (2 of 8)6/27/2004 2:20:26 AM