. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-10
Installing the Hub
Writer: Chris Seiter Project: Installing the Hub Comments: 299440-001
File Name:2824_3.DOC Last Saved On:6/26/97 11:00 AM
Connecting Power
Follow these steps to connect the hub to power:
1. Plug the power cord into the power connector on the back of the hub.
2. Insert the three-pronged plug on the power cord into a non-switched
grounded power source. The power source should be near the hub and
easily accessible.
Figure 3-8. Connecting the Power Cord
When you plug in the power cord, the hub performs a self test in which the
RJ-45 LEDs are green (or yellow if collisions are occurring), off, yellow, and
off again. Each state is about ½ second in duration. After the test, the POWER
LED lights steady green.