Compaq 6500 manual Audio and IR Troubleshooting

			Troubleshooting
Audio and IR Troubleshooting
	Problem	Possible Cause	Action
	Sound is not	Audio volume needs to	Adjust audio volume by pressing the
	working.	be increased.	[fn]+[s] hot key combination.
		System audio has been	Check the sound icon located on the
		turned off.	Windows Taskbar. If sound is
			disabled/muted, press [fn] + [F7] to toggle
			on the internal audio feature.

	Configuration problem.
File does not	FIR port is disabled.
transfer.
	Obstructed transmission
	path.
	Your FIR port is located
	too far from and out of
	plane with the other
	device’s Infrared
	module.
	Transmission subjected
	to excessive noise levels.

From the Windows Control Panel double- click the System icon and verify the sound device is properly configured and the drivers are loaded.

Press [fn] + [F3] to enter the System Setup and enable the Infra-Red Port. Refer to Chapter 4 if you require additional information about System Setup.

Ensure that there is a clear, unobstructed path between the two Infrared modules.

Position your notebook closer to the other device’s Infrared transceiver. For best results, keep transmission distances less than or equal to 1 meter and a bias angle of less than 15 degrees.

Do not transmit Infrared signals near equipment with compressors, such as refrigerators or air conditioners.

6-9