Compaq SCSI warranty Service and Support, QuickSpecs, Standard Features, Rack Airflow Requirements

QuickSpecs

Compaq ProLiant ML330 Generation 2 (G2)

Standard Features

Rack Airflow Requirements	•	Rack 9000 and 10000 series Cabinets
		The increasing power of new high-performance processor technology requires increased cooling
		efficiency for rack-mounted servers. The Compaq 9000 Series Rack and the new 10000 Series Racks
		provides enhanced airflow for maximum cooling, allowing these racks to be fully loaded with servers
		using the latest processors.
	•	Rack 7000 series Cabinets
		When installing a server with processors running at speeds of 550 MHz or greater in Compaq Rack
		7000 series racks with glass doors (165753-001 (42U), and 163747-001 (22U)), the new processor
		technology requires the installation of Compaq’s new High Airflow Rack Door Inserts (327281-B21
		(42U), 327281-B22 (42U 6 pack), or 157847-B21 (22U)) to promote enhanced airflow for maximum
		cooling.

CAUTION: If a third-party rack is used, observe the following additional requirements to ensure adequate airflow and to prevent damage to the equipment:

oFront and rear doors: If your 42U server rack includes closing front and rear doors, you must allow 5,350 sq cm (830 square inches) of hole evenly distributed from top to bottom to permit adequate airflow (equivalent to the required 64 percent open area for ventilation).

oSide: The clearance between the installed rack component and the side panels of the rack must be a minimum of 7 cm (2.75 inches)

	CAUTION: Always use blanking panels to fill all remaining empty front panel U-spaces in the rack. This
	arrangement ensures proper airflow. Using a rack without blanking panels results in improper cooling that can
	lead to thermal damage.
	Note: For additional information, refer to the Setup and Installation Guide or the Documentation CD provided with
	the server, or to the server documentation located in the Support section at the following URL:
	http://www5.compaq.com/products/servers/proliantml330/index.html
Service and Support	Compaq Services provides a one-year, limited warranty, including Pre-Failure Warranty (coverage of hard drives,
	memory and processors) fully supported by a worldwide network of resellers and service providers. Compaq
	technical assistance is available 7x24, toll free in the United States and Canada. Telephone support services may
	be covered under warranty or available for an additional fee.
	Note: Limited Warranty includes 1 year Parts, 1 year Labor, 1-year on-site support.

A full range of CarePaq packaged hardware and software services:

−Installation and start up

−Extended coverage hours and enhanced response times

−System management and performance services

−Availability and recovery services

Note: For more information, customer/resellers can contact http://www.compaq.com/services

Please see the following URL regarding Warranty Information For Your Compaq Products:

http://www.compaq.com/support/warranty_upgrades/web_statements/176738.html

For additional information regarding Worldwide Limited Warranty and Technical Support, please see the following

URL: ftp://ftp.compaq.com/pub/supportinformation/ejourney/176738.pdf

Note: Certain restrictions and exclusions apply. Consult the Compaq Customer Support Center at 1-800-345-1518 for details.

DA-10961 World Wide — Version 18 — June 27, 2002 5