Compatible Systems V.35 specification

Octal V.35-10/100 RIOP Installation Guide, Version 1.0

FCC Notice: This product has been certified to comply with the limits for a Class A computing device, pursuant to Subpart J of Part 15 of FCC Rules. It is designed to provide reasonable protection against radio or television communication interference in a commercial environment. Operation of this equipment in a residential area could cause interference with radio or television communication.

Page 2

Image 2

Contents

Octal V.35 10/100 Riop Installation Guide Page Table of Contents Quickstart Instructions LED Patterns Shipping DefaultsAppendix a Connector and Cable Pin Outs Introduction to the Octal V.35-10/100 Riop Network Installation Connecting the Octal V.35-10/100 to the Ethernet Powering Up the Router Connecting a Line Device to the V.35 InterfacesConnecting a Management Console Telco Line Connection Requirements IP Protocol Ethernet Interface ConfigurationQuickstart Instructions Required for IP DECnet Protocol IPX ProtocolAppleTalk Protocol PPP Configuration WAN Interface ConfigurationPhysical Communications Settings WAN Link Configuration Frame Relay Configuration Required for IP Numbered Interface Frame Relay Dlci MappingsRequired for Dedicated Line Operation Required for IP Unnumbered Interface Suggested for IP Link Configuration Smds ConfigurationSaving a Configuration File to Flash ROM Smds Addressing WAN Interfaces Shipping DefaultsEthernet Interface LED Patterns Appendix a Connector and Cable Pin Outs Pin Outs for HD D-Sub Male to V.35 Male Cable

Compatible Systems V.35 manual

Models: V.35