Manuals / Brands / Computer Equipment / Network Card / Connect Tech / Computer Equipment / Network Card

Connect Tech Titan/cPCI Figure 3: Titan/cPCI TN003 Adapter with LEDs, Figure 2: Titan/cPCI Model TN004 for compatibility with 64 bit systems

1 34

Download 34 pages, 457.38 Kb

Titan/cPCI User’s Manual, Connect Tech Inc.

Titan/cPCI Adapter Model TN004 (Compatible with 64 bit systems)

Jumper blocks		½ Duplex Control
JC, JD, JE, JF		Jumper Block JA

DB-37

Connector

CompactPCI

Bus Connector

RS-232 Select	PCI 954
Jumper Block JB	Quad UART

Ejector

Handle

Figure 2: Titan/cPCI Model TN004 for compatibility with 64 bit systems

Titan/cPCI TN003 Adapter

(front panel LEDs)

Jumper blocks	½ Duplex Control
JC, JD, JE, JF	Jumper Block JA

Tx/Rx LEDs

Rear I/O

Connector

CompactPCI

Bus Connector

RS-232 Select	PCI 954
Jumper Block JB	Quad UART

Ejector

Handle

Figure 3: Titan/cPCI TN003 Adapter with LEDs

Revision 1.01

5

Contents

Tel: Email: sales@connecttech.com support@connecttech.com URL: Limited Lifetime Warranty Copyright Notice Trademark Acknowledgment Certification Statements Table of Contents Appendix A: Specifications Appendix C: Factory Settings Appendix D: RS-422/485Line Interface List of Tables List of Figures Introduction Customer Support Overview Contact Information Mail/Courier Email/Internet Note: Titan/cPCI Installation Overview Hardware Installation Figure 1: Titan/cPCI two and four port adapters Figure 2: Titan/cPCI Model TN004 for compatibility with 64 bit systems Figure 3: Titan/cPCI TN003 Adapter with LEDs Figure 4: Titan/cPCI Rear I/O two and four port adapters Figure 5: Titan/cPCI Rear I/O Opto two and four port adapters Figure 6: 10-portconfiguration using Front and Rear I/O Titan/cPCI Software Software Installation Installing the Titan/cPCI adapter in your system Titan/cPCI and Rear I/O adapters Configuring the Titan/cPCI Baud Rate Selection RS-422/485Line Interface Full Duplex Mode Appendix D: Software Installation Appendix A: Specifications Surge Suppression Optical Isolation Titan/cPCI Rear I/O Opto (2 & 4 port models): Dimensions Connectors/Interface Appendix B: Connectors/Pinouts Table 2: DB-37cable connector pinouts Table 3: Appendix C: Factory Settings Titan/cPCI Rear I/O Opto adapters Appendix D: RS-422/485Line Interface Full Duplex Mode (4 wire) not installing Half Duplex RS-422/485(2 wire) Multi-dropSlave Mode (4 wire) Figure 7: RS-422/485Partial Schematic Technical Notes: Titan/cPCI Rear I/O Opto 2 and 4 port adapters no bias or termination jumpers clear of all jumpers Jumpers JA Description Titan/cPCI Rear I/O Opto Electrical Interface Selection Full Duplex Mode (4 wire) Half Duplex RS-422/485(2 wire) Multi-dropSlave Mode (4 wire) Figure 8: RS-422/485partial schematic for Rear I/O Opto Figure 8: Page RS-422/485Cable Wiring Figure 9: Figure 10: