![](/images/backgrounds/141940/141940-346x1.png)
Titan/cPCI User’s Manual, Connect Tech Inc.
Introduction
Connect Tech’s Titan/cPCI and Titan/cPCI Rear I/O adapters are high performance
Titan/cPCI adapters provide the
You must have the corresponding number of Titan/cPCI serial ports installed in the front I/O in order to use a Titan/cPCI Rear I/O or Titan/cPCI Rear I/O Opto adapter in your system. Titan/cPCI Rear I/O and Rear I/O Opto adapters provide the
when you have a Titan/cPCI Rear I/O adapter installed the corresponding number of ports in the front I/O section are not available.
Features:
●Two or four asynchronous serial ports from one slot
●
●Full
Full Duplex Mode
Half Duplex Mode
●16C950 UARTs
●Independent baud rate selection per port offering baud rates from 50 bps to 1.8342 Mbps
●TransGuard Transient Voltage Suppression (surge suppression – IEC
●CompactPCI rear I/O capability (Please contact your Connect Tech Sales representative for further information concerning the available rear I/O options for your Titan/cPCI adapter)
●Jumper selectable +5 V DC or +12 V DC output on pin 6 of the
●Each port is independently optically isolated to 3.0kV AC peak to peak (Titan/cPCI Rear I/O Opto models only)
●Ability to install any number of Titan/cPCI adapters that your system can accommodate(For Rear/IO, you can install up to the same number of Titan/cPCI Rear I/O and Rear I/O Opto serial ports as Titan/cPCI serial ports already installed in your system.)
Revision 1.01 | 1 |