provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications . However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
•Fixture must be connected to a 120 Volt, 60 Hz power source. Any other connection voids warranty.
•Installation must be in accordance with the National Electrical Code and local building codes.
•Aim lampholder adapter a minimum of 15 degrees below horizontal.
•Locate motion sensor a minimum of 3” away and below lampholder.
•For proper operation and protection against damage, the motion sensor head adjustment knobs must be facing the ground.
•Use maximum 150W BR type bulb. This retrofit unit is not designed to use with
•Do not exceed maximum watta ge marked on existing fixture.
•Disassembly of your adapter will void the warranty.
SAVE THESE INSTRUCTIONS.
For best results
• Install your fixture | D |
detector is less sensitive above 10 feet). |
•Locate fixture so motion moves across detection zone (D).
•Locate fixture away from heat producing sources to prevent false triggering. Also be very careful not to include objects such as windows, white walls, and water in the detection zone whenever possible.
•Locate fixture away from moving objects such as trees and street traffic.
•Do not install more than one
Installation and mounting
Step 1: Turn off the power at the main fuse/breaker box.
Step 2: If necessary, allow bulb in fixture to cool before removing. Remove bulb from the light socket.
Step 3: Screw the adapter into the light socket. Make sure the coiled cord protrudes from the bottom of the adapter once it is installed. It may be necessary to rotate the lampholders to accomplish this.
Step 4: Replace the bulb.
3
