MD42FLW_FLB
attempt to use with other electrical fixtures! These connectors are designed to withstand the temperature and voltage requirements of this Cooper Lighting, LLC product only.
Step 2: Attach your ground supply wire to the fixture using the green ground screw.
Step 3: Connect black fixture wire to black supply wire (hot). Secure with wire nut (not included).
Step 4: Connect white fixture wire to white supply wire (neutral). Secure with wire nut (not included).
Step 5: Be careful to connect the wires correctly. Make sure no bare strands of wire extend from the wire nut or other approved wire connectors (not included).
Attaching access cover and lens
Step 1: If your fixture is to be mounted to a standard lampholder mounting plate, remove the
Step 2: Attach the access cover (C) to the light fixture using |
|
| Fig. 6 | |
access cover mounting screws (D) provided (Fig. 7). |
|
|
|
|
Note: Make sure all wiring is inside of the fixture arm before |
|
|
|
|
|
|
|
| |
the access cover is secured. |
|
|
|
|
Step 3: Attach the lens to the housing by carefully lining up |
|
|
|
|
the slots on the lens to the tabs on the housing. |
|
| Fig. 7 | |
Carefully insert the slots over the tabs, and twist the |
|
|
|
|
|
|
|
| |
lens clockwise until it locks into place (Fig. 8). |
|
|
|
|
Locate the lens lock screw (F) in the hardware bag. |
|
|
|
|
Place this screw in the screw hole located at the top |
|
|
|
|
front of the fixture (Fig. 9). Tighten the screw to hold |
|
|
|
|
the lens in place. |
|
|
|
|
|
| Fig. 8 | ||
Installing the bulb
Step 1: Screw the bulb (J) securely into socket.
Step 2: Back the bulb out one or two turns, then screw bulb back to insure proper position in socket.
Operating your fixture |
| Fig. 9 | |
Step 1: Turn on the power at the main fuse/breaker box. | |||
| |||
Step 2: Turn power on to the fixture. Your fixture should come on for 1 – 4 minutes, then go off during daylight installation.
Step 3: To test your fixture, cover the light sensor for 1 – 3 minutes. Your fixture should come on. Uncover the sensor, and your fixture should turn off in 1 – 4 minutes.
Installing the optional light shield/reflector
Note: Sometimes fixtures are installed in locations that receive too much reflected light. The photo sensor may have trouble telling the difference between daylight
Call for customer service and/or missing or damaged parts
ENGLISH
5
