Cooper Lighting installation instructions Large, INDOOR P2R, Visor and Non-Visor

Installation Instructions

Sheet 1 of 3

Vault

C-Scroll

Roundel

Large, INDOOR

P2R

(Pendant, 2-way, Remote ballast)

Visor and Non-Visor

Warning: Before starting any work ensure that all sources of power are turned off. All work must meet local/national codes and be performed by a certified electrician. Do not

These installation instructions are valid with the above Ametrix styles.

mount fixtures vertically.

Exploded view and part call-out

Canopy	#8-32 x3/8"
	Set screw
	(2x)
1/4-20 x4"
Hex bolt	Cover plate
(2x)	(2x)

Fixture head assembly

Attention:

Large fixtures require additional bracing/structure

around J-box to support fixture.

2Wiring the fixture

1/4-20 x4 Hex bolts (2x)

Cover plate

1.Slide fixture assembly onto pendant and secure with both 1/4-20 x4 hex bolts.

2.Attach appropriate wires and ensure all connections are properly matched

3.Secure cover plate

1Mounting pendant to ceiling

	J-box
3/8" fasteners	(by others)
(by others)
#8-32 x3/8"	Canopy
Set screw
(2x)
Cover plate
	1/4-20 x4
	Hex bolts
	(2x)

1.Remove both 1/4-20 x4 hex bolts from bottom of pendant.

2.Remove both #8-32 x3/8" set screws and allow canopy to slide down pendant.

3.Run wires from J-box into pendant, ensure there is enough wire to reach cover plate.

4.Using appropriate fasteners, secure fixture to ceiling. Use additional bracing around J-box to support fixture.

5. Replace canopy and secure using both set screws.

3Aiming the fixture

#10-32 End screw

Yoke arm	Fixture head
indicator	indicator

1.To aim fixtures, loosen both #10-32 end screws on one fixture. When both indicators are lined up, the slope of the lens face is 40-degrees. Each subsequent notch is an additional +/- 10-degrees.

2.When fixture head is rotated to the desired angle, retighten end screws to secure the position.

3.Repeat for second fixture head.

ADY071471 REV A(ECN070347)