Cooper Lighting SC1000R instruction manual Use as a portable light, Fig. E

FIG. A

SC1000R I.S 325-1439 6/4/04 4:12 PM Page 6

ENGLISH

and place it upright on the ground. Loosen the wing nuts holding the tab handles and raise the handles to an upright posi-

tion. Open the door on the other side of the cage using the same procedure as above. Stabilizing legs on both doors must be lowered down to stabilize

and level cage/stand prior to attaching portable fix- ture to the pole. Lower the stabilizing legs by loosen-

ing the oval knobs and pulling down on the legs until

the desired length has been achieved. Lock legs in the desired posi- tion by tightening the oval knobs (Figure E).

Step 2: Adjust the vertical pole to the desired height by loosen-
ing and tightening the collars on the pole (Figure F).
Lower the travel handle by pushing out and down on
the handle.
Step 3: Lift center handle of fixture by loosening the knob on
the back of the handle’s vertical tube and raising the	FIG. E
handle. (Figure G) Tighten the knob to hold handle in
“up” position. NOTE: Handle must be in “up” position
before using handle to avoid contacting the housing
when carrying portable unit. Attach portable fixture to
the vertical pole by placing the Quick-ReleaseTMcollar
over the top of the tube. Tighten the knob on the collar
until the screw is secure.
Step 4: Plug light into a GFCI protected 120-volt receptacle. To	FIG. F
turn light ON, or OFF, push red switch on the back of
each fixture.
NOTE: Cage must be secured with sand bags or other suitable
weight:
• When used on uneven or rocky surfaces	FIG. G
• When used in windy areas

• Anytime extra stability is required.

Use as a portable light

Step 1: Release the light fixture from the cage door by carefully unlatching the locking clamp on the center pole of the door. This is done by pulling out on the lock lever and disengaging the top hook end. The portable unit will remain supported by the lower hook. Open the door opposite the locking clamp. To open the door, first release the spring loaded door locks by pulling the lock knob towards the center of the door until the latch pin clears the hole. Rotate the door until it stops with the knee action locking bars fully extended. Remove the portable light fixture by first raising the unit off of the hook. Lower the portable fixture to the floor of the cage, and lean the top of the unit towards the open door. Pull the portable fixture out of the cage. Loosen the wing nuts holding the tab handles and raise the handles to an upright position. Tighten the wing nuts.

Step 2: Lift center handle of fixture by loosening the knob on the back of the handle’s vertical tube and raising the handle. (Figure H) Tighten the

6