SERIES 75 INSTALLATION MANUAL
Figure 1
STEP 1.
Mount wall angle as shown in Figure 1.
Angles must be mounted level and true for fixtures to mount correctly
8'(TYPICAL)
WALL ANGLE PROVIDED
IN 8” SECTIONS
CUT LAST SECTION TOFINISHED CEILING FIT AVAILABLE SPACE
1/4"
Figure 2
Use |
|
fixture housings to structure. | 90° OUTSIDE |
Based on field dimension | CORNER |
| |
aluminum housing to fit, using |
|
| |
|
|
| · NOTE “A” |
brackets may be required |
after cutting aluminum |
housings |
| · NOTE “B” |
STEP 1.
Attach housing to wall angle. Support
housing to structureJOINING PLATE with tie-wire.
STEP 2.
Install fixture from left to right, beginning with larger housing to smaller. Aluminum housing should be installed on right end of the run.
STEP 3.
Join fixture using joining plates.
STEP 4.
Align fixture using aligning clips.
Series 75R Installation Manual, Page 1 of 2
STEEL
HOUSING
SPACER BLADE
ALUMINUM
HOUSING
CLEVIS BRACKET ALIGNER CLIPS
(SEE DETAIL “B”)
A
Last housing of run is |
aluminum, to be field cut by |
installing contractor. |
· For packing purposes, |
aligning clips and spacer |
blades are mounted at end |
of housing as shown in |
detail “A”. |
· When installing housings, |
spacer blades will maintain |
a proper opening. |
· Prior to housing installation, |
reposition spacer blades |
and aligning clips shown in |
detail “B”. |
· Prior to installing shielding |
element, remove and |
discard spacer blades for all |
shielding elements except |
S72 bold bae. |
B
100 Andrews Rd., Hicksville, NY 11801 • Phone:
