Haier CWH08A Prepare Window for Installation, Positionthe Air Conditioner, Attach Adhesive Seal

Models: CWH08A

1 34
Download 34 pages 51.29 Kb
Page 7
Image 7
Prepare Window for Installation

Prepare Window for Installation

Attach Adhesive Seal

1.Cut the adhesive seal to the width of the lower window sash.

2.Remove the backing from the seal and attach the seal to the bottom of the lower window sash.

Install L Brackets

1.Measure the width of the window opening and mark the center line on the outside windowsill.

A

B

A. Width of window opening

B. Center line

2.Use ¹⁄₈" drill bit to drill a starter hole for each of the two L brackets located 7¹⁄₂" from the center line.

3.Using ³⁄₄" screws, install the L brackets on the outside windowsill. The short side of the brackets should face toward the outside.

 

B C

A

D

 

B

F

 

E

 

E

 

A. Outside windowsill

D. Center line

B. ³⁄₄" screw

E. 7¹⁄₂"

C. Inside windowsill

F. Short side of L bracket

IF AC IS BLOCKED BY STORM WINDOW

Add wood as shown in FIG.6, or remove storm window frame before air conditioner is installed.

If storm window frame must remain, be sure the drain holes or slots are not caulked or painted shut.

Accumulated rain water or condensation must be allowed to drain out.

Positionthe Air Conditioner

Attach Adhesive SealWARNING

Excessive Weight Hazard

Use two or more people to move and install air conditioner.

Failure to do so can result in back or other injury.

NOTES:

Handle air conditioner gently.

Be sure your air conditioner does not fall out of the opening during installation or removal.

The place where the power cord exits the air conditioner should be:

-Heat/Cool Models - no more than 4 ft (122 cm) from a grounded outlet.

-Cool Only Models - no more than 6 ft (182.9 cm) from a grounded outlet.

Do not block the louvers in the front panel.

Do not block the louvers on the outside of the air conditioner.

1.Center air conditioner in window. Be sure the bottom channels on the air conditioner drop into the notches of the L brackets. Lower the window sash behind the top channel to hold cabinet in place.

NOTE: Your model may differ from the one shown.

B

A

C

A. Side curtain against window channel

B. Window sash behind top channel

C. Bottom channel in bracket notches

7

Page 7
Image 7
Haier CWH08A Prepare Window for Installation, Positionthe Air Conditioner, Attach Adhesive Seal, Install L Brackets, B A C