INSTALLATION INSTRUCTIONS
|
| |
| COMBOLIGHT | |
Avoid Fire or Electric Shock | | | |||
R | TRIMMED | ||||
|
|
|
| Page 1 of 3 |
*Installation Instructions for qualified electricians only. *Install per National Electrical Code and local regulations. *Read Installation Instructions completely before installation. *Failure to follow Installation Instructions may void warranties.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
FIXTURE MOUNTING:
1.Fixture must be mounted using either BUTTERFLY MOUNTING BRACKETS or HANGER BARS (Contact RSA Dealer for HANGER BARS).
INSTALLATION NOTE:
DO NOT install insulation within 3in of any part of the Luminaire.
Blinking light of this thermally protected Luminaire may indicate overheating.
BUTTERFLY MOUNTING:
2. | Fixture comes equipped with universal BUTTERFLY MOUNTING |
| BRACKETS that can take common 1" or |
| MOUNTING CHANNELS (supplied by others). See Fig 1. |
3. | Position fixture so the MOUNTING CHANNELS lie on top of the ceiling |
| runners. |
4. | Fasten MOUNTING CHANNELS securely to ceiling runners. |
5. Secure MOUNTING CHANNELS to universal BUTTERFLY MOUNTING | |
| BRACKETS with wire tie downs. |
6. The BUTTERFLY MOUNTING BRACKETS are | |
| should be set so that the APERTURE COLLAR will be flush with the |
| SCREW |
JBOX | JBOX COVER |
Figure 2
9.A clean, square hole in the CEILING MATERIAL must be cut. Install the ceiling material below housing as seen in Fig 4.
10.Replace the TRIM into the HOUSING by connecting the TORSION SPRINGS to the HOUSING. Push the TRIM into the HOUSING until flush with the CEILING MATERIAL as seen in Fig 4.
finished ceiling plane. |
MOUNTING
CHANNEL
BUTTERFLY
MOUNTING
BRACKETS
HEX
SCREW
Figure 1
ELECTRICAL:
7.Remove the JBOX COVER from the JBOX by removing the four SCREWS. Connect supply lead wires to junction box lead wires in accordance with your local electrical code(s) or N.E.C. Replace JBOX COVER onto JBOX, securing with SCREWS. See Fig 2.
TORSION SPRING
TRIM
HOUSING
Figure 3
CEILING MATERIAL INSTALLATION:
8.Pull the TRIM away from the HOUSING. The TORSION SPRINGS will hold the TRIM onto the HOUSING. Compress the TORSION SPRINGS on each end of the TRIM, releasing the TRIM from the HOUSING. See Fig 3.
| HOUSING |
TRIM | CEILING |
Figure 4 | MATERIAL |