INSTALLATION INSTRUCTIONS
|
| |
| COMBOLIGHT | |
Avoid Fire or Electric Shock | | | |||
R | LAMPHOLDER | ||||
|
|
|
| Page 3 of 3 |
*Installation Instructions for qualified electricians only. *Install per National Electrical Code and local regulations. *Read Installation Instructions completely before installation. *Failure to follow Installation Instructions may void warranties.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
GIMBAL BRACKET (Standard Position)
GIMBAL BRACKET (Rotated 180° to "Down" Position)
Figure 9
17.Once removed, flip the two (2) GIMBAL BRACKETs around (180°) and tighten the joint if necessary. See Fig. 9.
If necessary, please see Step 21 for gimbal tightening instructions.
18.Reinsert the lamp ring assembly by turning it
GIMBAL | GIMBAL RING |
BLOCK | SNOOT |
|
SLOT
SET SCREW
Figure 10
19.To replace the COVER RING:
Push the COVER RING onto the BACK RING by lining up the BAYONET SLOTS (see Fig. 11) with the two (2) PINs in the BACK RING.
PIN
BACK RING
BAYONET
SLOTS
COVER
RING
Figure 11
20.Once lined up, push straight back until the COVER RING stops, then while keeping the COVER RING pushed back, turn clockwise until it pushes forward again slightly. See Fig. 12.
| COVER RING |
Figure 12 | (AS INSTALLED) |
21.Gimbal tightening instructions:
The lamp ring is intended to give positive tension at the PIVOT JOINTS so the lamp ring can be aimed by hand and held in place by tension.
*If a stronger, more secure lock is required then the PIVOT JOINTS (hex screws) may be tightened clockwise with a hex wrench tool. See Fig. 6. *Please note that in some conditions the COVER RING will need to be removed to gain access to the inner PIVOT JOINTS.