American Standard 6067.22X, 6065.22X Install Flush Valve Fig, Connect Flush Valve to Piping Fig

5INSTALL FLUSH VALVE; Fig. 8

1.Insert the side ADJUSTABLE TAILPIECE (1) on the FLUSH VALVE (2) into the SUPPLY STOP (3). Lubricate the TAILPIECE O-RING (4) with water if necessary. Lightly tighten COUPLING NUT (5). Fig. 8.

Important: Do not use lubricants (other than water) or any type of thread sealing paste or tape.

Fig. 8
3
	1
5	4
2

6CONNECT FLUSH VALVE TO PIPING; Fig. 9

1.Align the FLUSH VALVE (2) (Fig. 9) directly above the VACUUM BREAKER TUBE (7) and VACUUM COUPLING NUT (6). Make sure that GASKET (10) is installed.

Note: There is a +13mm, -6mm (+1/2, -1/4) tolerance for the 121mm (4-3/4) dimension. Fig. 9.

2.Pull the VACUUM BREAKER TUBE (7) up to meet the threaded FLUSH VALVE CONNECTION (8) and hand tighten the COUPLING NUT (6). Align all components of the flush valve assembly. Fig. 9.

3.Lightly tighten the TAILPIECE COUPLING NUT (5) connection first, then the VACUUM BREAKER COUPLING NUT (6) and finally the SPUD COUPLING NUT (9). Once alligned correctly, use a wrench to tighten all couplings to make water tight connections.

Fig. 9.

4.Secure piping behind wall as required.

Fig. 9

121mm,+13mm, -6mm (4-3/4)(+1/2, -1/4)

2	5
8
	10
6

7

9

5 M968550 REV. 1.5