Zenoah EXZ2610DL owner manual Set up, Mounting Engine, Installing Handle, Connecting Throttle Wire

EXZ2610DL

6. Set up

MOUNTING ENGINE	INSTALLING HANDLE
	(BC-EX, LRT-EX only)

NOTE

The handle is put during the arrow mark.

G B

1.Push the shaft tube toward the clutch housing and rotate it by hand to check that the drive shaft is en- gaged with the gears.

2.Insert the shaft tube into the clutch housing until it bottoms, and align the positioning holes on the clutch housing and the shaft tube and install the screw. When difficult to engage, twist the engine slightly.

3.Fasten the clamp securely with two screws.

IMPORTANT

Tighten the screws gradually by turns.

CONNECTING THROTTLE WIRE

1.Remove the air cleaner cover.

2.Connect the end of the throttle wire to the joint on the top of the carburetor.

M3 screw

Adjuster

Insert the cable to the end of

adjuster

Full on stopper

Idling adjust screw

1.Connect throttle wire with carburetor. Insert the cable to the end of adjuster fix the throttle cable by tighten- ing M3 screw. (Tightening torque: 0.4 ~ 0.8 N.m.)

2.Make sure the ‘STOPPER-PLATE’ of carburetor moves to contact with ‘IDLING ADJUST SCREW’ and the ‘SWING-ARM’ of carburetor moves to contact with ‘FULL ON STOPPER’ by gripping throttle lever.

CONNECTING SWITCH WIRES

•Connect the switch wires between the engine and the main unit. Pair the wires of the same color.

MINSPACING

About 19 inches (48 cm)

•Mount the handle to the shaft tube and suspension point it at a location that is comfortable to you.

(PS-EX only)

•Insert the grip to the shaft tube.

•Fasten the clamps with screws.

(HE-EX only)

•Install the J-shaped handle to the shaft tube and clamp at a position best for your job.

JOINT ATTACHMENT

SUSPENSION POINT

NOTE

Be the SUSPENSION POINT in

SUSPENSION

Knob bolt

the location of the arrow mark.

POINT

arrow mark

•Insert the attachment to the main shaft.

•Tighten the knob bolt securely.

GB-11