![](/images/new-backgrounds/1167442/16744227x1.webp)
EXZ2610DL
6.Set up (PS-EX only)
4.Adjust the chain tension by turning the tensioner screw until the tie straps just touch the bottom side of the bar rail.
(1) Chain tension adjusting screw
(a) Loosen | (b) Tighten |
5.Tighten the mounting nut securely with the bar tip held up (TORQUE: 8.9 ~ 11.7 N.m./90 ~ 120
(1) Tighten
WARNING
It is very important to maintain the proper chain tension. Rapid wear of the guide bar or the chain coming off easily can be caused by improper ten- sion. Especially when using a new chain, take good care of it since it should expand when first used.
BALANCE UNIT
1.Put on strap and attach unit to strap.
2.Depending on the working posture, slide clamp up or down until unit balances and the strap fits your body.
6.Set up (HE-EX only)
1.Insert the drive shaft into the clutch drum, then attach the gearbox to the shaft tube as aligning the position- ing holes. Wipe out grease on the tube and the inside of the gearbox. Screw in the lock screw and fasten the clamp bolt firmly.
(1)Clamp bolt
(2)Lock screw
2.Install the blade guard to the angle transmission with the provided 3 screws, then clamp it to the shaft tube with 2 screws.
3.Place the blade between the cutter holders (A) and
(B) while locking the gear shaft by putting the bar, one of the tools provided, through the key holes on the holder (A) and the angle transmission. Use the socket and the screwdriver as shown in the picture below to tighten the blade mounting bolt.
(1)Blade mounting bolt
(2)Cutter holder (B)
(3)Blade
(4)Bar
(5)Cutter holder (A)
4.Split the bracket and install the wheel assembly to the shaft tube and clamp at a position best for your job.
Bracket