8. Operation
5. Set the stop switch to the |
trigger to the start position (1 → 2 → 3). |
Place the unit on a flat, firm place. |
EXZ2610DL
7.Move the choke lever downward to open the choke. And restart engine.
Keep the cutting head clear of everything around it. |
(1)
1
2
3
(1) Stop switch
(1)
(2)
(3)
G B
6.While holding the unit firmly, pull out the starter rope quickly until engine fires.
WARNING
The product is equipped with a centrifugal clutch mechanism, so the cutting attachment begins to ro- tate as soon as the engine is started by putting the throttle into the start position. When starting the en- gine, place the product onto the ground in a flat clear area and hold it firmly in place so as to ensure that neither the cutting part nor the throttle come into contact with any obstacle when the engine starts.
IMPORTANT
•Avoid pulling the rope to its end or returning it by re- leasing the knob. Such actions can cause starter fail- ures.
(1)Choke lever (2) Close (3) Open
8.Allow the engine to warm up for a several minutes before starting operation.
NOTE
1.When restarting the engine immediately after stop- ping it, leave the choke open.
2.Overchoking can make the engine hard to start due to excess fuel. When the engine failed to start after several attempts, open the choke and repeat pulling the rope, or remove the spark plug and dry it.
STOPPING ENGINE
1.Release the throttle lever and run the engine for half a minute.
2.Shift the stop switch to the STOP position.
IMPORTANT
•Except for an emergency, avoid stopping the engine while pulling the throttle lever.
IMPORTANT
•When it doesn’t stop at the stop switch, move the choke level to the closed position.
(1)Choke lever
