EXZ2610DL
6.Set up (BC-EX only)
INSTALLING CUTTING ATTACHMENT GUARD
•Put the cutting attachment guard on the gearbox, at- tach it with the 4 screws and hardware provided.
4.When correctly adjusted, check the correct working of the harnesses' QUICK RELEASE.
(1)
(1) | Cutting attachment guard | (2) | |
(2) | Plate | ||
| |||
(3) | Screw | (3) |
INSTALLING CUTTING HEAD
1.While locking the gear shaft, by inserting the supplied tool into the upper holder on the gearbox, loosen and remove the hexagon nut
2.Then screw in the cutting head to the gear shaft over the holders.
HARNESS
WARNING
ALWAYS WEAR THE PROVIDED HARNESS WHEN USING THE MACHINE!
Always make sure the machine is hooked securely to the harness.
If you don't, you will be unable to control the machine safely. This can result in injury to yourself or others. Never use a harness with a defective quick release or any other damage.
HOW TO WEAR
1.Wear the provided harness without twisted bands, with the hanger on your right side.
(1)
(1) Hanger
BALANCE THE UNIT
1.Hook your machine to the hanger.
2.Adjust the bands of the harness to have the blade parallel to the ground when standing in your normal working position to provide you most effectiveness and comfort on operating the machine.
3.In order to prevent the hanger position to change during operation, turn up the extra part of the band from the buckle.
QUICK RELEASE
The harness is equipped with a "QUICK RELEASE"devise. To release the machine from the harness in emergency situations, please follow the procedure as explained below.
WARNING
Make sure to check proper working of the QUICK RE- LEASE device BEFORE operating the machine. Make sure to hold the unit securely when using the
QUICK RELEASE.
While holding the unit by your right hand securely, press both sides of the
buckle. sides of the buckle.
(1) Buckle
(1)
