EXZ2610DL
8.Operation (PS-EX only)
Adjust the pump as follows:
1.Stop the engine and make sure the stop switch is in the OFF position.
2.Place the unit on its side with the oil reservoir up.
(1) Oil tank (2) Chain cover
IMPORTANT
The oil flow adjusting screw must be pressed in slightly in order to turn. Failure to do so could damage the pump and screw.
3.With a screwdriver, push in on the oil flow rate adjust- ing screw and turn in the desired direction (there are three incremental settings):
(a)
(b)Counter
(c)Middle
WARNING
•Always wear work gloves made of leather or some other sturdy material when using the polesaw.
•Falling branches may fall onto the face or into the eyes, resulting in injuries, scratches, and cuts, and for this reason you should always be sure to wear a helmet and face protector when using your polesaw.
8.Operation (HE-EX only)
WARNING
•Always wear eye protection such as safety goggles. Never lean over the rotating cutting head. Rocks or other debris could be thrown into eyes and face and cause serious personal injury.
•Keep the blade guard and the mad guard attached in place at all times when the unit is operated.
•Before starting a job, check the area and remove all obstacles and objects that could be thrown by the blade.
•Do not adjust the wheel height or try to remove anything entangled to the blade with the engine running.
1.Before starting the engine, adjust the wheel height for desired cutting depth (see page 15).
2.Before starting a job, plan your direction of travel so that you can always hold the edger on you right side and can walk on a hard surface as much as possible.
3.When starting to edge, run the engine at full throttle, and slowly have the blade cut into the edge groove.
BLADE
ROTATION
NOTE
•Do not use the
