ED/DF300 30” CCM330/430/530/630/830/1030 Nordic Style Lid Kit Installation Instructions
INSTALLATION INSTRUCTIONS
ED/DF300 30” CCM330/430/530/630/830/1030 NORDIC BLACK/GRAY
STYLE LID KITS
This Nordic style kit applies to the Cornelius 30” wide CCM330/430/530/630/830/1030 ice maker.
Item | Part No. | Name | Qty. | |
No. | ||||
|
|
| ||
|
|
|
| |
1 | 15209 | Adapter Lid | 1 | |
|
|
|
| |
2 | 22127 | Bracket | 2 | |
|
|
|
| |
3 | 50904 | RTV | 1 | |
|
|
|
| |
4 | 52946 | Cover, Gray | 1 | |
| 52964 | Cover, Black |
| |
|
|
|
| |
5 | 91957 | Label | 1 | |
|
|
|
| |
6 | 620042919 | Baffle, Ice | 1 | |
|
|
|
| |
7 | 70226 | #10 x 3/4” Sheetmetal Screw | 12 | |
|
|
|
| |
8 | 620701902 | Acorn Nut, | 4 | |
|
|
|
| |
9 | 620701901 | Sealing Washer | 4 | |
|
|
|
| |
10 | 611701903 | #8 Nylon Washer | 4 | |
|
|
|
| |
11 | 15192 | Lid Opening Cover (For | 2 | |
|
| Icemakers) |
| |
|
|
|
| |
12 | 630500109 | Bin Stat | 1 | |
|
|
|
|
CAUTION: Disconnect electrical power to the dispenser before proceeding with the icemaker adapter kit installation.
WARNING: The dispenser must be secured with
NOTE: Adjust the automatic agitation timer located in the dispenser’s electrical control box to 5 seconds on, 20 minutes off. Access to the timer is provided by removing the merchandiser/upper front panel.
1.Unpack kit.
2.Remove the two (2) screws from each side of the dispenser cabinet and the plastic hopper covers
(2)that were shipped with the unit.
3.Place the Adapter lid on the unit and use the four (4) screws that were removed to fasten the lid in place.
4.Install the ice baffle on the lid assembly as shown in Figure 2.
IMPORTANT: The baffle prevents ice from
5.Seal the ice maker to the top of the dispenser after determining the correct location for the ice maker (see Figure 1).
A.Run beads of RTV around the opening in the lid and inside of the perimeter of the ice maker outline so that the ice maker will set on the RTV.
B.Set the ice maker onto the lid and position it as required.
C.Wipe away the excess RTV.
6.Drill .136 diameter holes into the ice maker cabinet and the dispenser lid using the ice maker mounting brackets as templates. USE CAUTION SO AS NOT TO DRILL INTO ANY ICE MAKER COMPONENTS (CONDENSER, TUBING, ETC.). Secure the brackets using the #10 sheet metal
screws provided.
Release Date: October 5, 2007 | www.cornelius.com | Revision: A |
© 2007, IMI Cornelius Inc. | - 1 - | Publication Number: 620204732INS |