CAUTIONS (Continued) | ENGLISH |
|
|
|
|
CAUTION for 200 - 240V operation only
This equipment relies on the protective devices in the building installation for
Informative examples of
protective devices in single - phase equipment or sub - assemblies
|
|
|
| Protection | Minimum number | Location |
|
|
|
| against | of fuses or circuit - |
|
|
|
|
|
| breaker poles |
|
Case A: | Equipment to be | Earth faults | 1 | Phase conductor | ||
connected to POWER SYSTEMS | Overcurrent | 1 | Either of the two | |||
with earthed neutral | reliably |
|
| conductors | ||
identified, except for Case C |
|
|
| |||
below. |
|
|
|
|
|
|
Case B: | Equipment to be | Earth faults | 2 | Both conductors | ||
connected | to | any | supply, | Overcurrent | 1 | Either of the two |
including IT POWER SYSTEMS |
|
| conductors | |||
and supplies | with reversible |
|
|
| ||
plugs, except for Case C below. |
|
|
| |||
Case C: | Equipment to be | Earth faults | 2 | Each phase conductor | ||
connected to | Overcurrent | 2 | Each phase conductor | |||
systems with earthed | neutral |
|
|
| ||
reliably identified. |
|
|
|
| ||
Verify that the protective devices in the building installation meets the conditions in the table prior to installing the equipment.
Be careful of static electricity on CRT surface !
To prevent electrical shock by the static electricity on the CRT surface, disconnect the power cord at least 30 seconds after turning OFF the power.
Avoid frequent power ON-OFF switching !
Do not repeat OFF and ON power switching in a short period. This may cause blurred colors or distortion of the displayed pattern.
Be careful of generated magnetism !
After the power has been turned ON or when the degauss function has been manually engaged, the CRT is demagnetised for approximately 7 seconds. This generates a strong magnetic field around the front cover which may affect the data stored on magnetic tape or disks near the front cover. Place such magnetic recording equipment and tapes/disks away from this unit.
About cleaning
Before cleaning, turn OFF the power switch and disconnect the plug from the power outlet. For the screen, use water with a lightly moistened soft cloth such as a gauze type material. For the cover, use water or a liquid synthetic detergent, with a lightly moistened soft cloth. Do not clean the inside of monitor by yourself as it is very dangerous. Refer to your dealer.
Do not use aerosol sprays, solvents or abrasive cleaners.
24
