UNIT SETUP |
|
FACTORY PRESETS |
|
The following table shows the default factory settings: | |
Display | Setting |
LANGUAGE | English |
STUTTER TONE | No |
AREA CODE | No Setting |
LDS CODE | 1 |
TIME & DATE | No Setting |
FLASH TIMER | 600 ms |
RINGER CADENCE | 3 |
RINGER VOLUME | 5 |
VOICEMAIL NUMBER | No Setting |
#3 SEC PAUSES | No Setting |
VM PASSWORD | No Setting |
HOLD MODE | Normal |
RELEASE MODE | New Call |
Note: After the unit has been completely configured | for the first time, use MENU |
to review or reprogram the features. |
|
After the adapter is connected, the display will show as indicated below for setting.
1.[SELECT LANGUAGE] appears on the display. Press REVIEW UP to select the language. ENG - English, ESP - Spanish, FRE - French, and then press MENU to confirm the selection.
2.When [ENTER AREA CODE] appears, enter the desired area code using
the keypad. Use REVIEW UP and REVIEW DOWN to skip a digit. Press MENU to confirm area code. Follow the same procedure for both area code settings. To leave an area code blank, press MENU without entering digits.
3.When [SET LDS CODE] appears, enter the desired LDS code using the keypad. Press MENU to confirm the selection.
4.When [EDIT TIME & DATE] appears, enter the time using the keypad. Press REVIEW UP and REVIEW DOWN to select AM or PM. Enter the date using the keypad. Press MENU to confirm the settings.
Example: To enter 8:35 AM, enter 0835 and then press REVIEW UP to skip to the date because the time is AM by default.
5.When [FLASH TIMER (MS)] appears, press REVIEW UP to toggle between 600ms, 100 ms, and 300ms. After selecting the desired flash time, press MENU to confirm selection.
11
