Country Home Products 10 HP manual Engine Bolts, Front Belt Tensioner Clutch

NOTE: After you perform the adjustment, make sure that the Key remained in the Rotor Shaft and flush with the end surface of the Shaft (Figure 11 on page 30).

c)Apply Loctite® 243 to the threads of the Set Screws and reinsert them into the Drive Pulley Hub.

d)Tighten the Set Screws while maintaining the alignment of the Clutch and Rotor Pulley (Figure 11).

e)Recheck the alignment after tightening the Set Screws.

6. Reinstall the Belt Guard.

NOTE: Check and re-tighten the Drive Belt, if necessary, after an initial break-in period of one (1) hour.

Engine Bolts, Front

Belt Tensioner

Figure 9

Clutch Rotor Pulley

Belt

Straight Edge

Figure 10

CALL TOLL FREE 1-800-DR-OWNER 29