Tools Needed:
•5/16" Wrench
•3/16" Allen wrench
•1/2" socket and ratchet
1.Using a 5/16" Wrench, remove both Access Covers (Chipper and Drive Side) from the Chipper Box (Figure 14).
2.Rotate the Chipper Disk using a stick until the three (3) countersunk Allen Screws and Lock Nuts attaching the Knife to the Flywheel are visible through the Access Openings (Figure 14).
3.Clean out the heads of the Allen Screws with an awl or sharp tool.
4.Insert a 3/16” Allen wrench into the head of a screw.
5.While holding the Allen wrench, remove the Lock Nut using a 1/2" socket.
6.Repeat Steps 4 and 5 for the remaining two (2) Allen screws.
7.Remove the dull or damaged Knife and visually inspect the Chipper Disk Slot and Knife mounting area and be sure they are clean and that the replacement Knife will be able to mount flush against the Chipper Disk.
8.Install a new or sharpened Knife and finger tighten the Allen screws and Lock Nuts (new hardware is supplied with a new Knife) to hold the Knife to the Chipper Disk.
9.Using a 3/16" Allen wrench and a 1/2" socket, tighten the center Screw and Nut, then tighten the outer Screw and Nut, and finally tighten the inner Screw and Nut.
10.
11.Replace the Access Covers.
12.Check the gap between the Knife and Wear Plate. See “Adjusting the Knife to Wear Plate Gap” on page 33.
Allen Screw
3 places
Knife
Access Cover removed,
Chipper side.
Figure 14
32 DR® 10 HP CHIPPER
