Attaching the Chipper Hopper
Tool Needed:
•(2) 1/2" Wrench or Socket
Tip: Insert a towel or large rag into the opening to keep the Bolts from falling into the Chipper.
1.Attach the Chipper Hopper to the machine using four (4)
NOTE: Be sure to insert the bolts from the inside of the Chipper Hopper so that the threads are sticking out (Figure 1).
2.Install a Flat Washer, then a Lock Nut on each bolt. Initially install the Bolts and Nuts finger tight and then tighten the Nuts one (1) turn using two (2) 1/2" wrenches (Figure 1). Check to see that the Hopper is centered on the Inlet Chute and then tighten the Nuts securely.
3.If you used a towel or rag in the Chipper opening, remove it now.
Bolt (4)
Nut (4)
Chipper Hopper
Access Cover
Washer (4)
Inlet Chute
Chipper Left Side Panel
Figure 1
BE SURE TO FILL THE ENGINE WITH OIL AND GAS BEFORE USE. IF YOU START THE ENGINE WITHOUT OIL IN THE CRANKCASE, THE ENGINE WILL BE DAMAGED BEYOND REPAIR AND WILL NOT BE COVERED UNDER THE WARRANTY. SEE THE NEXT PAGE FOR OIL AND FUEL FILL.
Check the Tire Pressure
There should be 30 psi in each tire.
CALL TOLL FREE | 13 |
