Country Home Products 6-TON Tools and Parts Supplied, Additional Tool Required

Unpacking and Assembling the DR 6 -TON ELECTRIC WOOD SPLITTER

NOTE: Read this Safety & Operating Instructions Manual before using your new DR 6 -TON ELECTRIC WOOD SPLITTER. The wood splitter shipped from the factory fully assembled with the exception of the Wheels and the Operation Handle. The following instructions will detail how to unpack and assemble the machine.

Tools and Parts Supplied:

•6mm Hex Wrench

•10 - 12mm Wrench

•13 - 16mm Wrench

•Operating Handle w/ Retaining Bolt and Washer

•(2) 6mm Bolts

•Extra Hydraulic Seal

•(2) Wheels

Additional Tool Required:

•Knife

STABILIZE THE SHIPPING CONTAINER ON A FLAT SURFACE BEFORE ATTEMPTING TO UNPACK AND ASSEMBLE THE MACHINE.

1.With the help of another person (the machine weighs 171 pounds), carefully roll the shipping carton over onto its top.

2.Carefully cut the tape along the bottom seam of the shipping carton with a knife, open the carton, and remove the Wheel from the packing; setting it aside (Figure 2).

3.Now, carefully roll the shipping carton back onto its bottom

(Figure 3) and lift the shipping carton off your new DR 6 -TON ELECTRIC WOOD SPLITTER (Figure 4). The machine should

now be resting on the Front Support Legs and the Rear Support. Figure 2

Bottom of carton

Remove Wheel

4.Remove the second Wheel from the packing (setting it aside) and any remaining packing materials from the machine. Do not discard your packaging material until you are fully satisfied with your new DR 6 -TON ELECTRIC WOOD SPLITTER.

Remove Wheel

Figure 4 Figure 3

Top of carton

Lift carton up

CALL TOLL FREE 1-800-DR-OWNER 11