Coway CHP-03AL Water Treatment Device, Certificate Number, 08, Trademark/Model Designation, VOCs

	State of California
	Department of Public Health
	Water Treatment Device
	Certificate Number
	08 - 1866
	Date Issued: June 24, 2008
Trademark/Model Designation	Replacement Element(s)
Mach CHP-03AL	WJNF11 Neo-Sense Filter
	WJMF11S-30 RO Membrane Filter
	WJCF11-POST Post-carbon Filter
	WJFF7 Fine Filter
	WJCC-02 Ceramic Filter
Manufacturer: Woongjin Coway Co LTD

The water treatment device(s) listed on this certificate have met the testing requirements pursuant to Section

116830 of the Health and Safety Code for the following health related contaminants:

Microbiological Contaminants and Turbidity	Inorganic/Radiological Contaminants
None	Arsenic (Pentavalent)1
	Barium
	Cadmium
	Chromium (Hexavalent)
	Chromium (Trivalent)
	Lead
	Nitrate/Nitrite2
	Radium 226/228
	Selenium

Organic Contaminants

VOCs

Alachlor	Endrin	Simazine
Atrazine	Ethylbenzene	Styrene
Benzene	EDB	1,1,2,2-Tetrachloroethane
Carbofuran	Haloacetonitriles (HAN)	Tetrachloroethylene
Carbon Tetrachloride	Bromochloroacetonitrile	Toluene
Chlorobenzene	Dibromoacetonitrile	2,4,5-TP (Silvex)
Chloropicrin	Dichloroacetonitrile	Tribromoacetic Acid
2,4-D	Trichloroacetonitrile	1,2,4-Trichlorobenzene
DBCP	Haloketones (HK)	1,1,1-Trichloroethane
o-Dichlorobenzene	1,1-Dichloro-2-Propanone	1,1,2-Trichloroethane
p-Dichlorobenzene	1,1,1-Trichloro-2-Propanone	Trichloroethylene
1,2-Dichloroethane	Heptachlor	Trihalomethanes (THMs)
1,1-Dichloroethylene	Heptachlor Epoxide	Bromodichloromethane
cis-1,2-Dichloroethylene	Hexachlorobutadiene	Bromoform
trans-1,2-Dichloroethylene	Hexachlorocyclopentadiene	Chloroform
1,2-Dichloropropane	Lindane	Chlorodibromomethane
cis-1,3-Dichloropropylene	Methoxychlor	Xylenes
Dinoseb	Pentachlorophenol

	Rated Service Capacity: 229 gal	Rated Service Flow: 0..07 gpm
	Do not use with water that is microbiologically unsafe or of unknown quality, without adequate disinfection
	before or after the system..
	1 Claims for arsenic reduction shall only be made on water supplies maintaining detectable residual free chlorine at the
	reverse osmosis (RO) system inlet. Water systems using an in-line chlorinator should provide a minimum of 1minute
	chlorine contact time before the RO system.
	2 This system is acceptable for treatment of influent concentrations of no more than 27 mg/L nitrate and 3 mg/L nitrite in
	combination measured as N and is certified for nitrate/nitrite reduction only for water supplies with a pressure of 280 kPa
35	(40 psig) or greater. A sampling and analysis test kit for nitrate is provided for checking the performance of this system.
	Frequent analysis is encouraged.