1101
1202
HOW TO REPLACE FILTER
Step1 Filter replacement time is indicated when the corresponding LED of filter flickers in window display.
Step2 Each of A, B and C respectively represents
RO membrane filter and fine post- carbon filter.
Step3 Close water
Step5 Remove fitting from filter as shown in diagram. Replace filters as required. Take caution for safety at all times.
Step6 Initialize filter setting by pressing the corresponding button(for 3 sec) of filter among the filter reset buttons located at the back of the front panel.
Step7 Insert both side covers and fasten screws.
Safety Information |
Operating Instructions |
Troubleshooting Tips
Step4 Unfasten screws. Then, hold both side covers at the bottom and force them upwards as if pushing up to remove them from the main body.
�
Step8 Check for normal operation of filter replacement parts in window display.
※Caution : When LED to indicate filter replacement is turned on, users must not attempt at replacing filters on their own. Make sure to inquire
Customer Service