09
10
HOW TO USE
WARNING
Make sure that there’s no water leakage before plugging in the power cord.
Preparation Before Use
Step1 Wind the teflon tape on the | Step2 Connect orange tubing with the |
adaptor and fit it to the pipe. | connector on the adaptor. |
Shall install the adaptor with | Flush water through each filter at |
connector on the cold water pipe. | least 5 minutes before connection. |
Then, connect the faucet with the adaptor.
▶The Usage Condition : The feed water is more than 2.5L/min, 17psi.
● This unit is the R/O type of purifier which needs an appropriate inflow quantity for proper performance. If the unit is set up in a way where the installation status is substandard, a malfunction such as excess noise and trembling can occur.
● The warning light for water shortage turns on for safety when the feed water pressure suddenly drops, or the inflow quantity decreases.
●This device is installed in one of two ways, depending on the
usage conditions.
● This product operates auto
How to Drink Water
Safety Information |
Operating Instructions |
Step3 Make a hole on the drain pipe | Step4 Connect the extraction fitting to the |
and install the drain clamp on | faucet with a tube. |
the hole. |
|
Step5 Connect the orange colored | Step6 Connect it to voltage rating |
inlet tubing for the feed water | that matches it on the rating |
with the cold water pipe. | plate. |
Extend the blue color outlet | Then, open the feed valve to |
tubing to where the drain is. | supply water to the filtration |
| system. |
Step1 Put the extraction pipe in the desired position and place the cup under the extraction faucet to collect the water.
Step3 Water extraction automatically stops after four minutes to prevent too much use of water or overflowing around the product caused by user’s carelessness. After repeating for eight cycles, this device will auto flush and then shut off.
Step2 Turn the faucet on and off depending on desired use of filtered water.
Step4 If the system does not work when the faucet is opened, push the restart button for one seconds to restart extraction.
Troubleshooting Tips Customer
Inlet tubing
�
● ●
�
Outlet tubing
�
Service