Enjoying Audio Sources

Turning On the A-9755/A-9555

POWER

STANDBY

indicator

STANDBY

ON

Note:

To shut down the A-9755/A-9555 completely, set the [POWER] switch to the OFF position ().

Selecting Speaker

1 A-9755/ A-9555

Press the [POWER] switch.

The A-9755/A-9555 retains the power mode (on/standby) in which the ampli- fier was the last time you turned off the system.

Notes:

The A-9755/A-9555 is shipped with the [POWER] switch in the OFF position (). When the power cord is connected for the very first time or the [POWER] switch is set to ON

() position, the A-9755/A-9555 will turn on.

When it’s turned on, the A-9755/A-9555 outputs no sound for about five seconds. This allows the circuits to stabilize.

You can select which set of speakers outputs sound. OFF: Select “OFF,” if you do not connect any speaker.

A:To output sound from the speakers connected to the SPEAKERS A terminals, turn the SPEAKERS selector to the “A” position.

B:To output sound from the speakers connected to the SPEAKERS B terminals, turn the SPEAKERS selector to the “B” position.

A+B: To output sound from all connected speakers, turn the SPEAKERS selector to the “A+B” position.

Note:

If the Volume indicator flashes quickly, make sure that the speakers are connected correctly.

2 Remote To set the A-9755/A-9555 to controller Standby, press the [STANDBY]

button on the remote controller. The STANDBY indicator lights up.

To turn the A-9755/A-9555 on,

press the [ON] button on the remote controller.

The STANDBY indicator goes off.

If the A-9755/A-9555 is connected to other compo-

nents via , press the remote controller’s [ON] but- ton once to turn on the A-9755/A-9555, and press it again to turn on the other components.

Turning on all system components simultaneously: You can set the A-9755/A-9555 so that all connected components are turned on with just one press of the remote controller’s [ON] button. To do this, turn on the A-9755/A-9555, and then press and hold the remote con- troller’s [ON] button for 16 seconds until the A-9755/A-9555 switches to Standby mode. You will then be able to turn on the A-9755/A-9555 and all sys- tem components with just one press of the remote con- troller’s [ON] button.

If you want to restore the setting to the original state, reset the A-9755/A-9555. For information about how to reset, see “How to reset” on page 19.

14

Page 14
Image 14
Onkyo A-9755* Enjoying Audio Sources, Turning On the A-9755/A-9555, Selecting Speaker, Press the Power switch