Quantum A-Series manual DC Power AC Power W MaxPk1 Max3 Mode Typ2 Typ4

				Functional Specifications
	Table 14 Power Requirements
— SCSI Interface
		DC Power		AC Power (W)
		MaxPk1		Max3
	Mode	Typ2		Typ4
	Standby/Idle	21	21	51	46
	Media Loading/Unloading	43	37	83	73
	600A Write – Motor Start5	32	29	78	71
	600A Write – Streaming	32	31	73	64
	Max for SDLT 600A tape drive Modes6	43	N/A	83	N/A

1.The Max-Peak value represents short current spikes drawn for durations of < 50ms. On the 12V supply, the peaks correspond to the pulse-width-modulated switching of the motors. These values are calculated from the average of Peak-ripple-current + 2 sigma, measured at nominal DC voltage.

2.The typical current is calculated from the average of all RMS current drawn during this operating mode, measured at nominal DC voltage.

3.The Max AC power is calculated from the typical AC power in tabletop tape drives + 3 sigma.

4.The Typical AC power is calculated from the average of AC power drawn in tabletop tape drives.

5.These events last < 1 second and occur at a duty cycle of less than 25%.

6.The Max values for each mode are based on the Max-Mean values, since the peak values are of very short duration.

(Common Notes)

(1)	Voltage tolerance: 5V ±5%, 12V ±5%; Room temperature 24 °C. AC power measured at 117 V, 60 Hz.
(2)	DC Current, MaxMean, and DC/AC Power Max refer to the statistically calculated maximum average
	requirement based on a sample population of tape drives. These values do not reflect the peak current or power
	requirement; this amount is given by the DC MaxPk current.
(3)	These results were from the DVT data taken by Percept Technology. Reference the “Power Consumption &
	Characterization Test Report” dated 11/28/2005.
(4)	Test data set included 12 measurements: 3 measurements of 4 drives.
(5)	The 5V “MaxPK” calculated to less than MaxRMS, which does not at first glance make sense. (MaxPK is
	calculated at 5.25V, and the switching power supplies need less input current to the same input current.)
	Instead, the MaxRMS value was substituted.

Quantum A-Series Tape Drives User’s Guide 40