Installation Instructions
B Electrical Connections
ATTENTION INSTALLER!!!
All electric wall ovens must be hard wired (direct wired) into an approved junction box. A plug and receptacle is NOT permitted on these products.
Do not shorten the flexible conduit.The conduit strain Relief Clamp must be securely attached to the junction box and the flexible conduit must be securely attached to the clamp. If the flexible conduit will not fit within the clamp, do not install the oven until a clamp of the proper size is obtained.
NOTE TO ELECTRICIAN: The 3 power leads supplied with this appliance are UL recognized for connection to larger gauge household wiring. The insulation of these 3 leads is rated at temperatures much higher than the temperature rating of house- hold wiring. The current carrying capacity of the conductor is governed by the temperature rating of the insulation around the wire, rather than the wire gauge alone.
WARNING: Improper connection of aluminum house wiring to copper leads can result in an electrical
hazard or fire. Use only connectors designed for joining copper to aluminum and follow the manufacturer’s recommended procedure closely.
B1 | Turn off the circuit breaker or remove fuses | |||
to the oven branch circuit. |
| |||
| With the oven in front of the cabinet | |||
B2 | ||||
opening, on a table or platform, connect the | ||||
| flexible conduit to the electrical junction box | |||
| ||||
| as shown below. You will need to purchase | |||
| a strain relief clamp to complete the | |||
| connection of the conduit to the junction | |||
| box. |
| ||
|
| 20" |
| |
|
|
| JUNCTION BOX | |
| CONDUIT | |||
| LOCATION | |||
| 48 1/2" |
| ||
| LONG |
| ||
BARE GROUND
RED
WHITE
BLACK
STRAIN RELIEF CLAMP
( NOT INCLUDED )
MUST BE USED
AT JUNCTION BOX
PLACE OVEN ON
ASUPPORT TO ASSIST IN CONNECTING
CONDUIT
6 | ( Continued on Next Page) |
