Placing the Oven in the Opening | Cowon Systems JKP85 specs

C Placing the Oven in the Opening

a.Loop (do not tie) a 36” string around the conduit before the oven is slid into place. This will keep the conduit from falling behind the oven.

Note: Before drilling the pilot holes make sure the oven is pushed as far back into the opening as it will go and centered.

a.Drill four-1/8” pilot holes through the mounting holes (top and bottom) of the side trim, for the eight #8 screws provided.

b. Lift oven into cabinet cutout using the oven

opening as an grip. Carefully push against

oven front frame. Do not push against

outside edges.

c. As you slide the oven back, pull the string

so that the conduit will lie on top of the oven

in a natural loop.

d. When you are sure the conduit is out of the

way, slide the oven 3/4 way back into the

opening. Remove the string by pulling on

The screws must be a minimum of 1/4” from the front of the cutout.

NOTE: Mounting screws must be used. Failure to do so could result in the oven falling out of the cabinet causing serious injury.

b. Secure the oven to cabinet with screws provided.

NOTE: If the cabinet is particle board, you must use 4 #8 x 3/4 particle board screws. These may be purchased at any hardware store.