TOOL KIT
Your unit is provided with a tool kit (Fig.l). This tool kit consists of the following:
4 mm Allen Wrench
5 mm Allen Wrench
_¢// 8 & 10 mm Wrench
_ Four 5 mm Screws
(/_with captive washers
I_ FourWashers
Straight Shaft models | |
include 2 Plate Washers | _ |
| Fig. 1 |
INSTALLING CUTTING ATTACHMENT SHIELD
Use the following instructions if the cutting attachment shield on your unit is not installed. Use only the instructions that apply to the type of shaft and shield that your unit is equipped with.
FOR CURVED SHAFT TRIMMERS
Place the cutting attachment shield and spacer against tube as shown in (Fig.2). Use the 2 screws provided
to clamp the cap and shield onto the tube. Tighten the screws evenly. Make sure the shield does not touch any rotating parts.
CuttingAttachment Shield
FOR STRAIGHT SHAFT TRIMMERS
Place the cutting attachment shield onto the shaft mount. Install using provided hardware in the sequence
as shown (Fig.3). | Ji |
Shaft Mount
\
II
I I
iCutting Attachment Shield
Plate Washer "'_ | _ |
Washer _
Lock Washer Attachin( Screws
Fig. 3
INSTALLING THE UPPER HANDLE AND SAFETY BAR
1.Locate the 4 screws included in the tool kit.
2.Assemble the upper handle, safety bar and 4 attaching screws as shown in (Fig.4). Position the handle parts evenly over the rubber sleeve on shaft. Do not com- pletely tighten.
3.While holding the unit in the operating position (Fig. 14), position the upper handle to the location that pro- vides you the best grip.
4.Tighten the clamp screws evenly, until the upper handle is secure.
Attaching
Screws "_'_I _ g
| (_jk.1U | pper Handle |
__u |
| bber_Sleeve |
SafetyBar | _ I |
|
| Fig. 4 |
|
| WARNING: |
|
To prevent serious injury, never operate the
trimmer without the cutting attachment
in place.
Fig. 2
