![](/images/new-backgrounds/1151547/15154721x1.webp)
4_Slidethetableassemblywiththerackontothe | 7_Instal!thetablecrankhandle(9)ontothewormgear |
column. | shaft(11) onthesideofthetablesupport(12)_ |
5_ Engagethebottomoftherack(5)withthelipofthe | 8_Lineuptheflatsideoftheshaftwiththesetscrew(10) |
columnsupport(6)_Tightenthetablebracketlock | inthecrankhandleandtightenthescrewwiththe |
handle(4)to lockthetableassemblytothecolumn. | 3mmhexwrenchprovided. |
Fig.D | Fig.F |
10
9
®
©
11
5
12
j6
J
6_ install the rack ring (7) on the column so the top lip of the rack sits into the rack ring.
IMPORTANT: The bottom of the collar MUST NOT be pushed all the way down onto the top of the rack. MAKE SURE the top of the rack is under the bottom of the collar and that there is enough clearance to al!ow the rack to freely rotate around the column. Tighten the set screw (8).
NOTE: To avoid column or collar damage, DO NOT OVERTIGHTEN the set screw.
Fig. E
8
7
5
INSTALLING THE HEAD (FIG. G}
IAWARNINGI
The Drill Press head is heavy and should be lifted with the help of two PEOPLE OR MORE to safely assemble the drill press head on the column.
1.Carefully lift the head (1) and slide it into the
column (2). Make sure the head slides down over the
column as far as possible. Align the head with the base.
2.Using the 4ram hex wrench provided, tighten the two head locking setscrews (3) on the right side of the head.
Fig. G
11