[AWARNING I
AVOID DIRECT EYE CONTACT
A Laser light is radiated when the laser guide is turned on. Avoid direct eye contact. Always un=plug the
drill press from the power source before making any adjustments.
A laser pointer is not a toy and should not come into hands of children. Misuse of this appliance can lead to irreparable eye injuries.
Any adjustment to increase the laser power is forbidden.
When using the laser pointer, do not point the laser beam towards people and/or reflecting surfaces. Even a laser beam of lower intensity may cause eye damage. Therefore, do not look directly into the laser beam.
If the laser pointer is stored for more than three months without use, please remove the batteries to avoid damage from possibly leaking batteries.
The laser pointer includes no servicing components. Never open the housing for repair or adjustments. On units equipped with the laser attachment, repairs shall only be carried out by the laser manufacturer or an authorized agent.
Laser Warning label: Max output <1mW DIODE LASER:630=670nm, Complies with 21CFR 1040.10 and 1040. 11.
ADJUSTING THE LASER LINES ( FIG. R)
A. How to check the
1.Adjust the table height so it is 5 in. below the bottom of the chuck.
2.Scribe a round circle (approx. 1/8 in.) on a piece of scrap wood.
3.insert a drill bit approx 1/8 in. diameter into the chuck and tighten.
4.Lower the quill and align the scribed circle with the drill bit and fasten the wood to the table.
5.Turn on the laser and verify the laser lines (x) are centered onto the scribed circle.
B. ALIGNING THE
1.Turn on the laser by pressing the rocker switch.
2.Lower the drill press quil! and loosen one turn each the four screws (4).
3.To adjust the laser beam left/right, turn the adjustment screw (1) no more than 1/8 turn in either direction. To adjust the laser beam front to back, turn the adjusting screw (2) no more than 1/8 turn in either direction.
4_ Once adjustments are completed, retighten the four screws (4)_
Fig. R
4
3
15
