Attachauxiliaryfenceto ripfencewithtwo"C"clamps. (Fig.dd)
Fig.JJ
[,_ WARNING 1
For your own safety, always replace the blade, blade guard assembly, and btade insert when you are finished with the dado operation. You must atso realign the blade guard assembly.
Fig. KK
DADO CUTS (FIG. KK)
IAWARNINGn
a. Only Stackabledado blades can be used on this
SaW.
b. DO NOT use Adjustable or Wobble type dadoes. c. Maximum dado cut width is 1/2in.
1.A dado table insert must be purchased separately for this saw to accept a dado blade. Remove saw blade and blade guard for dado cuts ONLY. Reinstall and realign blade guard for all through sawing operations. Install a dado not exceeding 6 in. in diameter and 1/2in. in width
2.install the dado table insert making sure the rear of the insert is flush with the table. A rubber adjusting spacer is provided under the rear of the insert for this purpose.
3.instruction for operating the dado is packed with the separately purchased dado set.
4.The arbor (1) on this saw restricts the maximum width of the cut to 1/=in.
5.tt is not necessary to install the outside
flange (2) before threading on the arbour nut (3) for maximum 1/=in. dado cuts. Make sure that the
arbor nut (3) is tight, and that st least one thread of the arbor sticks out past the nut.
6.Use only the correct number of round outside blades and inside chippers as shown in the dado set's instruction manual. Blade/chippers must not exceed 1/2in. total in width.
7.Check saw to ensure that the dado will not strike the housing, insert, or motor when in operation.
'li J J j2
"_ 3
{
21
